| Index | Thread | Archive | Aug-2002 | Archive | Send |
 |
  |
 |
   |
|
  |
|
> Judd, > > I have Force 12 monobanders for 10 thru 40, phased verticals on 160 and > plan a 4 sq array on 80. I only run one coax into the house for all 9 > antennas. > > The way I do it is run one coax out to the first tower and switch it with a > inline coax switch to three other towers. This coax switch is fed with > +, -, or 0 volts with an external wire. From the shack, I also feed 0, > +, -, or AC down the coax and out to the other towers. These inline coax > switches on three other towers then route the signal to the apporiate > antenna. > > I use a Top Ten Devices band decoder off the Mark V to automatically swith > the antennas. > > I have only two rotor cables run into the house. One for Hy Gain Tail > Twisters is swithed the same as above (use the same voltages and relays to > route the cable to the appropriate rotor. I have one M2 RC2800, and I did > run a seperate rotor cable. > > If you have any questions or would like a diagram, let me know > > Dick Williams K8ZTT > Franktown CO > -------------------------------------------- Force12Talk mailing list provided as a service by Force 12 Antennas, Inc. Force12 Web Site: http://www.force12inc.com To Submit Message to the List: Force12Talk@qth.com To unsubscribe and view the Message Archive: see http://qth.com/force12/list For problems with the list: contact n4zr@qth.com |
This Thread
|
This Author (Aug-2002)
|