Index Thread Archive May-2003 Archive Send
 Main index   Previous in threadNext in thread   Previous in archiveNext in archive   Index by Subject for May-2003Index by Author for May-2003Index by Date for May-2003   Index by Subject for ArchiveIndex by Author for ArchiveIndex by Date for Archive   Reply to messageNew message 

Subject: Intermittency?
Author: Dan <dhearn@ix.netcom.com>
Date: 05-May-2003 21:13:52
Dale: When you get her down I would try an ohmeter across each joint and
maybe wriggle the element while watching the meter. 73, Dan, N5AR
----- Original Message -----
From: Dale L Martin <kg5u@hal-pc.org>
To: <Force12Talk@qth.com>
Sent: Monday, May 05, 2003 7:00 PM
Subject: [Force 12 Talk] Intermittency?


>
> During the New England QSO Party, I noticed SWR on my C3E on 15m was about
> 2.5:1, much higher than usual. SWR was it's normally very low 1.1:1 on
20m.
>
> Since I was operating QRP, I went to tune mode and increased the power to
> 100 watts. As I did so, the SWR suddenly dropped to a more reasonable
> 1.2:1.
>
> Unfortunately, it did not 'take'. Back down to QRP level and the SWR was
> again 2.5:1 and fluctuating up and down around that.
>
> After the NEQP, I ran a coax jumper from the feedline entry point in the
> garage to the FT100 in the car and saw the same intermittency. Increasing
> power towards 100 Watts seemed to 'fix' the SWR back to normal levels.
>
> I figure it's an intermittency problem within one of the
elements/segments?
>
> I've a used C4 in the garage, so I guess this is the impetus I need to
> assemble it, take down the C3E and put up the C4.
>
> My thoughts about the intermitency is that I'm going to have to remove the
> rivets, clean the element segment contact surfaces, reapply noalox, and
> reassemble. I figure I should start with the 15m director and reflector
> elements first, then do the driver. Thoughts?
>
> I've also got the C4 upgrade kit (40m element and mounting kit) that I was
> going to put on the C3E. But now, it stays in the box. At least, until I
> get the C4 up on top (70').
>
> I've a Cushcraft A3 sidemounted on the tower at 40' and fixed on Northwest
> (W6/7/JA). I'm now thinking of taking it down and putting up the C3E
> (w/40m element) in it's place, once the intermittency problem is resolved.
>
> Any suggestions or ideas?
>
> 73,
> dale, kg5u
>
>
>
>
> --------------------------------------------
> Force12Talk mailing list provided as a service by Force 12 Antennas, Inc.
> Force12 Web Site: http://www.force12inc.com
>
> To Submit Message to the List: Force12Talk@qth.com
> To unsubscribe and view the Message Archive: see
http://qth.com/force12/list
> For problems with the list: contact n4zr@qth.com
>
>



--------------------------------------------
Force12Talk mailing list provided as a service by Force 12 Antennas, Inc.
Force12 Web Site: http://www.force12inc.com

To Submit Message to the List: Force12Talk@qth.com
To unsubscribe and view the Message Archive: see http://qth.com/force12/list
For problems with the list: contact n4zr@qth.com

This Thread
  Date   Author  
* 05-May-2003 Dan
05-May-2003 Dale L Martin
This Author (May-2003)
  Subject   Date  
* Intermittency? 05-May-2003